Remarkable Features ofcell phone jammer

Type in the Analysis Model Analysis will set the Thickness, plane for the selection or setting Datum plane to determine the situation of the plane flesh; Slice for the detection of the product between two sections flesh, Silce offset is the distance between the cross-section, and then Set minimum and maximum thickness, Computer, the system automatically calculates the results. When the flesh more than the maximum value of the excess is set to red wireframe to display; when the flesh is less than the minimum specified value, blue. Product testing and analysis is an important work of parting, to be taken seriously. The range can be enlarged after adding the directional antenna for cell phone jammer.
In the operation should be possible to identify all the doubts and resolve them through the following steps in a timely manner, to remove obstacles for future work. When errors are detected and disadvantages of the norm to do when: Appearance requested a review of the relative current tooling and production conditions we can meet customer requirements, how to achieve. Understand the product post-treatment processes, when the finished product to plating, the auxiliary flow path will be finished to do together, to separate them after the completion of plating; when the die to be spent dealing bite, make sure the mold draft angle is 3 degrees. Qualifying products, including mold, the form should best discharge location, location to be considered into the water and sub-surface and other factors, according to the size, structure and other factors to determine the cavity, such as 1X1, 1X2, 1X4, 1X8, 1X16, etc. cell phone jammer will do no damage to the cell phone.
When several products out of a mold in the same time, taking into account the uniformity of rubber. The product should be large in the middle position, place the product on both sides of the small. When several sub-surface irregular products in the same mold, the ranking must take full account of its sub-surface connections smooth. A mode, multi-cavity molds, when there are mosaic, sliders and other structures, not to cause interference. Ranking should be integrated in every aspect of Mold, convection Road, is mosaic, line position, top out, carrying water and other structures have a global thinking. Qualifying time in order to form the largest center for the positioning of the product base. Big outlet mold base, if the former model highly enough, the jack sank in the mouth in order to shorten the mold sprue length, the use of screws, the structure as shown. cell phone jammer also makes various mobile phones recover to use several seconds after it is turned off.